The USAlert WatchDog Pager Battery Cover is a standard part of the WatchDog housing and holds the batteries in place while also providing protection for the battery compartment. Individual covers can be ordered separately if damage occurs to the original part. The black polycarbonate cover is attached to the back of the WatchDog housing with a metal screw, but over-fastening the screw or excessive wear and tear to that part of the housing may at times damage the plastic. Since the Battery Cover can be easily removed and replaced, shipping the entire pager back for repair is not necessary. Both USAlert WatchDog and WatchDog LT pagers use the same interchangeable Battery Cover.
The WiPath LED Sign Programmer consists of a serial cable, a networking cable, a serial-to-network adapter, LED Sign programming software and LED Sign Pager Interface programming software. Initial setup of the LED Sign Programmer involves connecting the network cable to the LED Sign being programmed and to the serial-to-network adapter. The serial cable is also connected to the serial-to-network adapter and an available COM port on the computer. Apply power to the LED Sign. Install, run and configure the WiPath sign programming software named “LEDConfig”.