The USAlert NP35 Pager Programmer consists of a programming fixture labeled UB-08, a standard USB cable, and NP35 programming software. The USB cable connects to an operational USB port on the computer and to the NP35 programming fixture. Once attached, the green power LED on the fixture near the USB connection should light. The NP35 programming software is also used to program the USAlert Alpha 2 and NP40 pagers. The NP35 is designated as “J8” in the software, the Alpha 2 as “J25” and the NP40 as “J7”.
The USAlert NP35 Pager Belt Clip comes standard with every NP35 Numeric Pager. It is designed to allow easy removal of the pager from a belt to read or recall messages. Since it is detachable, individual Belt Clips can be ordered to replace any that may have been damaged or lost without having to send the pager back for repair. The Belt Clip can be released from the locking mechanism by using a small flat head screwdriver or similar device to pull the square plastic tab at the top of the clip away from the pager while also pushing up on the bottom of the Belt Clip. To attach a Belt Clip, fit it into the semi-circular slot on the back of the NP35 and slide it down until it “clicks” into place.